enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   The American National Standards Institute (ANSI) provides standards for general use flat washers. Type A is a series of steel washers at broad tolerances, where precision is not critical. Type B is a series of flat washers with tighter tolerances where outside diameters are categorized as "narrow", "regular" or "wide" for specific bolt sizes. [26]

3. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   The thread form is defined by flats at the tip and root of the thread form. This flat length is defined as the pitch divided by eight. The thread depth, which is from flat to flat is 0.6495 times the pitch. [4] For 1 ⁄ 4-inch (6.4 mm) screws and larger, the pitch is defined as: = +

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

5. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   Structural bolt DIN 6914 with DIN 6916 washer and UNI 5587 nut. ... Flat head fasteners: Ideal for ... (Inch Series) B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted ...

6. You can find huge savings in Amazon's secret overstock ... - AOL

   www.aol.com/lifestyle/you-can-find-huge-savings...

   Slicing and dicing just got way more fun, thanks to this colorful knife set from Cuisinart. You'll get an 8-inch chef knife, an 8-inch slicing knife, an 8-inch serrated bread knife, a 7-inch ...

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.