enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. 3D printing speed - Wikipedia

    en.wikipedia.org/wiki/3D_Printing_speed

    3D printing speed refers to only the build stage, a subcomponent of the entire 3D printing process. However, the entire process spans from pre-processing to post-processing stages. [ 5 ] The time required for printing a completed part from a data file (. stl or .obj ) is calculated as the sum of time for the following stages:

  3. V-twin engine - Wikipedia

    en.wikipedia.org/wiki/V-twin_engine

    A V-twin engine, also called a V2 engine, is a two-cylinder piston engine where the cylinders are arranged in a V configuration and share a common crankshaft. The V-twin is widely associated with motorcycles, primarily installed longitudinally, though also transversely. They are also used in a variety of other land, air, and marine vehicles, as ...

  4. Speeds and feeds - Wikipedia

    en.wikipedia.org/wiki/Speeds_and_feeds

    Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.

  5. EABA - Wikipedia

    en.wikipedia.org/wiki/EABA

    Initial criticism focused on the lack of many additional premade settings and the bland artwork. It did not sell incredibly well, and is relatively unknown among RPG fans. [6] The v2 edition also received excellent reviews, calling it "the bleeding edge of PDF game development", and praising the scalability and portability of the system. [7]

  6. V speeds - Wikipedia

    en.wikipedia.org/wiki/V_speeds

    Stall speed or minimum steady flight speed for which the aircraft is still controllable. [7] [8] [9] V S 0: Stall speed or minimum flight speed in landing configuration. [7] [8] [9] V S 1: Stall speed or minimum steady flight speed for which the aircraft is still controllable in a specific configuration. [7] [8] V S R: Reference stall speed. [7 ...

  7. Braunschweig LF-1 Zaunkönig - Wikipedia

    en.wikipedia.org/wiki/Braunschweig_LF-1_Zaunkönig

    The first prototype, the LF-1 V1, was built in 1940 and made its maiden flight, piloted by Winter himself, in December 1940. Test flights stopped in November 1942 after part of the wing ruptured causing the aircraft to crash. In 1943 a second prototype, the V2, was built, receiving the registration D-YBAR.

  8. Droop speed control - Wikipedia

    en.wikipedia.org/wiki/Droop_speed_control

    In this case, speed reference will be 104% and actual speed will be 100%. For every 1% change in the turbine speed reference, the power output of the turbine will change by 25% of rated for a unit with a 4% droop setting. Droop is therefore expressed as the percentage change in (design) speed required for 100% governor action.

  9. ELM327 - Wikipedia

    en.wikipedia.org/wiki/ELM327

    The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.