enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Asynchronous serial interface - Wikipedia

    en.wikipedia.org/wiki/Asynchronous_serial_interface

    The ASI output of a DVB Integrated Receiver/Decoder (IRD). It carries the entire MPEG transport stream being received from a DVB satellite feed entering the RF input (far left side in picture). Asynchronous Serial Interface , or ASI, is a method of carrying an MPEG Transport Stream ( MPEG-TS ) over 75-ohm copper coaxial cable or optical fiber ...

  3. AS-Interface - Wikipedia

    en.wikipedia.org/wiki/AS-interface

    Actuator Sensor Interface (AS-Interface or ASi) is an industrial networking solution (Physical Layer, Data access Method and Protocol) used in PLC, DCS and PC-based automation systems. It is designed for connecting simple field I/O devices (e.g. binary ON/OFF devices such as actuators, sensors, rotary encoders, analog inputs and outputs, push ...

  4. Distribution amplifier - Wikipedia

    en.wikipedia.org/wiki/Distribution_amplifier

    An audio distribution amplifier also known as: a press feed; a pool feed; a media feed; press box; or an ADA, takes a single audio feed, usually a line input, but it may be a microphone input, and outputs multiple line or microphone outputs. This can be done using a passive feed, where the signal is split among the outputs, or as an active feed ...

  5. Distributed amplifier - Wikipedia

    en.wikipedia.org/wiki/Distributed_Amplifier

    The design of the distributed amplifiers was first formulated by William S. Percival in 1936. [1] In that year Percival proposed a design by which the transconductances of individual vacuum tubes could be added linearly without lumping their element capacitances at the input and output, thus arriving at a circuit that achieved a gain-bandwidth product greater than that of an individual tube.

  6. RF distribution amplifier - Wikipedia

    en.wikipedia.org/wiki/RF_Distribution_Amplifier

    A RF distribution amplifier is a high−performance distribution amplifier for analog RF signals. It takes one RF signal and carries it to multiple identical outputs. [1]

  7. Serial digital interface - Wikipedia

    en.wikipedia.org/wiki/Serial_digital_interface

    The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...

  8. Constant-voltage speaker system - Wikipedia

    en.wikipedia.org/wiki/Constant-voltage_speaker...

    Constant-voltage speaker systems refer to networks of loudspeakers which are connected to an audio amplifier using step-up and step-down transformers to simplify impedance calculations and to minimize power loss over the speaker cables. They are more appropriately called high-voltage audio distribution systems. [1]

  9. Sansui AU-11000 - Wikipedia

    en.wikipedia.org/wiki/Sansui_AU-11000

    The amplifier is known across the audiophile community for its high-output power and low Total harmonic distortion (THD). The AU-11000 has an output power of 110 watts -per- channel , [ 1 ] and was one of the earliest home audio amplifiers to use multiple transistors per channel using a "Push-Pull" method to add more amplification power.