Search results
Results from the WOW.Com Content Network
In a manual transmission vehicle, stop-start is activated by stopping the car, shifting the gear to neutral, and releasing the clutch. The engine will not stop if the car is moving, even if the aforementioned steps are followed (this is not true for all cars). The engine restarts when the clutch is pressed prior to selecting a gear to move the car.
The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec). When the current is removed from the clutch, the armature is free to turn with the shaft. Springs hold the friction disks away from each other, so there is no contact when the clutch is not engaged, creating a minimal amount of ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
The AOL.com video experience serves up the best video content from AOL and around the web, curating informative and entertaining snackable videos.
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Cars with manual gearshift use a clutch. Clutches are controlled from pedal by bowden cable or hydraulic systems, some use the fluid in common with the brake system. As a dead end of the hydraulic system, the slave cylinder is equipped with a bleed screw.