Search results
Results from the WOW.Com Content Network
To express the efficiency of a generator or power plant as a percentage, invert the value if dimensionless notation or same unit are used. For example: A heat rate value of 5 gives an efficiency factor of 20%. A heat rate value of 2 kWh/kWh gives an efficiency factor of 50%. A heat rate value of 4 MJ/MJ gives an efficiency factor of 25%.
When there is enough flow, power output is limited by plant generating capacity. The maximum power-output curves were calculated based on the average flow rate at the dam site, assuming the water level is 175 m and the plant gross efficiency is 90.15%. The actual power output in 2008 was obtained based on the monthly electricity sent to the grid.
The six-year project would begin in 2013 and extend the plant's life by at least forty years and upgrade the generating capacity from 1,872 megawatts to 2,172 megawatts. [10] Plans for the upgrade include replacing all six of the plant's turbines, which would increase the plant's total generating capacity by 15 percent, and efficiency by 5 percent.
Variable speed operation further optimizes the round trip efficiency in pumped hydro storage plants. [ 5 ] [ 6 ] In micro-PSH applications, a group of pumps and Pump As Turbine (PAT) could be implemented respectively for pumping and generating phases. [ 7 ]
For example, a low-head hydro power plant with hydrostatic head of few meters to few tens of meters can be classified either as an SHP or an LHP. [30] The other distinction between SHP and LHP is the degree of the water flow regulation: a typical SHP primarily uses the natural water discharge with very little regulation in comparison to an LHP.
Hydropower (from Ancient Greek ὑδρο-, "water"), also known as water power or water energy, is the use of falling or fast-running water to produce electricity or to power machines. This is achieved by converting the gravitational potential or kinetic energy of a water source to produce power. [1] Hydropower is a method of sustainable energy ...
The energy efficiency of a fuel cell is generally between 40 and 60%; however, if waste heat is captured in a cogeneration scheme, efficiencies of up to 85% can be obtained. [24] World average fossil fuel electricity generation power plant as of 2008 [25] Chemical to electrical Gross output 39%, Net output 33% Electricity storage: Lithium-ion ...
In a conventional thermal power plant, like a coal-fired power station or nuclear power plant, the energy created by the chemical or nuclear reactions is absorbed in a working fluid, usually water. In a coal plant, for instance, the coal burns in an open chamber which is surrounded by tubes carrying water.