Search results
Results from the WOW.Com Content Network
The USB 3.1 specification takes over the existing USB 3.0's SuperSpeed USB transfer rate, now referred to as USB 3.1 Gen 1, and introduces a faster transfer rate called SuperSpeed USB 10 Gbps, corresponding to operation mode USB 3.1 Gen 2, [62] putting it on par with a single first-generation Thunderbolt channel.
USB 3.0 is the third major version of the Universal Serial Bus (USB) standard for interfacing computers and electronic devices. Among other improvements, USB 3.0 adds the new transfer rate referred to as SuperSpeed USB (SS) that can transfer data at up to 5 Gbit/s (625 MB/s), which is about 10 times faster than the USB 2.0 standard.
The USB interface is vulnerable to security exploits such as BadUSB that abuse the combination of USB's ability to connect many different kinds of devices, its inability to verify that devices are actually what they claim to be, the possibility for USB devices to change their type or announce additional subdevices while plugged in, and its ...
However, the SuperSpeed USB part of the system still implements the one-lane Gen 1×1 operation mode. Therefore, two-lane operations, namely USB 3.2 Gen 1×2 (10 Gbit/s) and Gen 2×2 (20 Gbit/s), are only possible with Full-Featured USB-C. As of 2023, they are somewhat rarely implemented; Intel, however, started to include them in its 11th ...
Charging with induction (left image) creates more waste heat than using a cable (right image). The following disadvantages have been noted for low-power (i.e., less than 100 watts) inductive charging devices, and may not apply to high-power (i.e., greater than 5 kilowatts) electric vehicle inductive charging systems.
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
The power station was completed in 1959, and has 292.6 metres (960 ft) rated head. [2] The first 330 kV transmission lines were commissioned in New South Wales at the Tumut 1 Power Station during the 1950s. These cables were manufactured in England and linked to the underground transformers at Tumut 1, and connected with the transmission line ...
Some isolated chargers may be used in parallel. This allows for an increased charge current and reduced charging times. The battery has a maximum current rating that cannot be exceeded; Non-isolated: the battery charger has a direct electrical connection to the A/C outlet's wiring. Non-isolated chargers cannot be used in parallel.