Search results
Results from the WOW.Com Content Network
Lime mortar or torching [1] [2] is a masonry mortar composed of lime and an aggregate such as sand, mixed with water. It is one of the oldest known types of mortar, used in ancient Rome and Greece, when it largely replaced the clay and gypsum mortars common to ancient Egyptian construction. [3]
The ancient Romans used a type of lime mortar that has been found to be self-healing. [8] The stratlingite crystals form along the interfacial zones of Roman concrete, binding the aggregate and mortar together and this process continued even after 2000 years and it was discovered by the geologist Marie Jackson and her colleagues in 2014.
Hydraulic lime concretes have been in use since Roman times, either as mass foundation concretes or as lightweight concretes using tufa or pumice as aggregates and a wide range of pozzolans to achieve different strengths and speeds of set. This meant that lime could be used in a wide variety of applications including floors and even vaults or ...
In the lime industry, limestone is a general term for rocks that contain 80% or more of calcium or magnesium carbonate, including marble, chalk, oolite, and marl.Further classification is done by composition as high calcium, argillaceous (clayey), silicious, conglomerate, magnesian, dolomite, and other limestones. [5]
Lime plaster is a type of plaster composed of sand, water, and lime, usually non-hydraulic hydrated lime (also known as slaked lime, high calcium lime or air lime). Ancient lime plaster often contained horse hair for reinforcement and pozzolan additives to reduce the working time.
Harling is a rough-cast wall finish consisting of lime and aggregate, known for its rough texture. [1] Many castles and other buildings in Scotland and Ulster have walls finished with harling. It is also used on contemporary buildings, where it protects against the wet Scottish and Ulster climates and eliminates the need for paint.
German masons repointing a wall in 1948. Repointing is the process of renewing the pointing, which is the external part of mortar joints, in masonry construction. Over time, weathering and decay cause voids in the joints between masonry units, usually in bricks, allowing the undesirable entrance of water.
The main components of LC3 cements are clinker, calcined clay, limestone, and gypsum. [24] [25] [26] The fresh concrete production involves synergetic hydration.[10] [27] Adding large amounts of calcined clay and ground limestone to the dry cement powder, [28] [29] when adding water to the mix for making concrete, cement and additives start to hydrate and the soluble aluminates released in ...