Search results
Results from the WOW.Com Content Network
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
{{convert|100|lb|kg}} → 100 pounds (45 kg) The unit-codes should be treated as case-sensitive: {{convert|100|Mm|mm}} → 100 megametres (1.0 × 10 11 mm) The output of {{convert}} can display multiple converted units, if further unit-codes are specified after the second unnamed parameter (without the pipe separator). Typical combination ...
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
It follows, therefore, that 1000th of a litre, known as one millilitre (1 mL), of water has a mass of about 1 g; 1000 litres of water has a mass of about 1000 kg (1 tonne or megagram). This relationship holds because the gram was originally defined as the mass of 1 mL of water; however, this definition was abandoned in 1799 because the density ...
Based on a method published in 1931 by H.N.Marsh, [1] a Marsh cone is a flow cone with an aspect ratio of 2:1 and a working volume of at least a litre. A Marsh funnel is a Marsh cone with a particular orifice and a working volume of 1.5 litres.
In medicine, IV drips deliver 10, 15, 20, or 60 drops per ml. Micro-drip sets deliver 60 drops per ml and 10, 15, or 20 drops per ml for a macro-drip set. [2]