Search results
Results from the WOW.Com Content Network
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers ( eax , ebx , etc.) and values instead of their 16-bit ( ax , bx , etc.) counterparts.
The 8086 [3] (also called iAPX 86) [4] is a 16-bit microprocessor chip designed by Intel between early 1976 [citation needed] and June 8, 1978, when it was released. [5] The Intel 8088, released July 1, 1979, [6] is a slightly modified chip with an external 8-bit data bus (allowing the use of cheaper and fewer supporting ICs), [note 1] and is notable as the processor used in the original IBM ...
x86 (also known as 80x86 [3] or the 8086 family [4]) is a family of complex instruction set computer (CISC) instruction set architectures [a] initially developed by Intel, based on the 8086 microprocessor and its 8-bit-external-bus variant, the 8088.
EVEX.W is used to specify floating-point format (0=FP32, 1=FP64) The bottom opcode bit is used to select between packed and scalar operation (0: packed, 1:scalar) For a given operation, all the scalar/packed variants belong to the same AVX-512 subset. The instructions all support result masking by opmask registers.
The Intel x86 computer instruction set architecture has supported memory segmentation since the original Intel 8086 in 1978. It allows programs to address more than 64 KB (65,536 bytes) of memory, the limit in earlier 80xx processors.
The x86 instruction set has several times been extended with SIMD (Single instruction, multiple data) instruction set extensions.These extensions, starting from the MMX instruction set extension introduced with Pentium MMX in 1997, typically define sets of wide registers and instructions that subdivide these registers into fixed-size lanes and perform a computation for each lane in parallel.
This process is much faster than sending out an address, reading the opcode and then decoding and executing it. Fetching the next instruction while the current instruction is being decoded or executed is called pipelining. [8] The 8086 processor has a six-byte prefetch instruction pipeline, while the 8088 has a four-byte prefetch. As the ...
In the x86 assembly language, the JMP instruction performs an unconditional jump. Such an instruction transfers the flow of execution by changing the program counter.There are a number of different opcodes that perform a jump; depending on whether the processor is in real mode or protected mode, and an override instruction is used, the instructions may take 16-bit, 32-bit, or segment:offset ...