Search results
Results from the WOW.Com Content Network
Explosive boiling can be best described by a p-T phase diagram. [3] Figure on right shows a typical p-T phase diagram of a substance. The binodal line or the coexistence curve is a thermodynamic state where at that specific temperature and pressure, liquid and vapor can coexist.
A BLEVE–fireball at the Philadelphia Energy Solutions refinery, as rendered by the CSB. A boiling liquid expanding vapor explosion (BLEVE, / ˈ b l ɛ v iː / BLEV-ee) is an explosion caused by the rupture of a vessel containing a pressurized liquid that is or has reached a temperature sufficiently higher than its boiling point at atmospheric pressure.
Littoral explosion at Waikupanaha ocean entry at the big island of Hawaii was caused by the lava entering the ocean. A steam explosion is an explosion caused by violent boiling or flashing of water or ice into steam, occurring when water or ice is either superheated, rapidly heated by fine hot debris produced within it, or heated by the interaction of molten metals (as in a fuel–coolant ...
Boilover onset mechanism. The extreme violence of boilovers is due to the expansion of water from liquid to steam, which is by a factor of 1500 or more. [3] In practical storage scenarios, the presence of water under the burning fluid is sometimes due to spurious accumulation during plant operation (e.g., rainwater entering a seam in the tank roof, off-specification products from the source ...
DNB is also known as transition boiling, unstable film boiling, and partial film boiling. For water boiling as shown on the graph, transition boiling occurs when the temperature difference between the surface and the boiling water is approximately 30 to 130 °C (54 to 234 °F) above the T S. This corresponds to the high peak and the low peak on ...
Source: Gregory Kroll/YouTube. Apparently, the reverse science also applies. Tossing in molten hot salt (up to 550 degrees Celsius) into a body of water will also cause an explosion ...
Depressurisation reduces the boiling point of the water, so when depressurised the water suddenly boils. [5] Or it may happen when groundwater is suddenly heated, flashing to steam suddenly. [ 6 ] When the water turns into steam, it expands at supersonic speeds, up to 1,700 times its original volume.
Prior to bringing regulations in line with the United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS) in 2012, OSHA considered flammable liquids to be those with a flash point below 37.8 °C/100 °F. Those with flash points above 37.8 °C/100 °F and below 93.3 °C/200 °F were classified as combustible liquids.