Search results
Results from the WOW.Com Content Network
Normality is defined as the number of gram or mole equivalents of solute present in one liter of solution.The SI unit of normality is equivalents per liter (Eq/L). = where N is normality, m sol is the mass of solute in grams, EW sol is the equivalent weight of solute, and V soln is the volume of the entire solution in liters.
As an example, given a concentration of 260 mg/m 3 at sea level, calculate the equivalent concentration at an altitude of 1,800 meters: C a = 260 × 0.9877 18 = 208 mg/m 3 at 1,800 meters altitude Standard conditions for gas volumes
To calculate the transformation efficiency, divide the number of colonies by the number of cells plated and multiply by 100. The result will be the transformation efficiency as a percentage. For example, if you plate 1x 10 7 cells and count 1000 colonies, the transformation efficiency is: (1000/1x 10 7 ) x 100 = 0.1%
The following formulas can be used to calculate the volumes of solute (V solute) and solvent (V solvent) to be used: [1] = = where V total is the desired total volume, and F is the desired dilution factor number (the number in the position of F if expressed as "1/F dilution factor" or "xF dilution"). However, some solutions and mixtures take up ...
The dilution in welding terms is defined as the weight of the base metal melted divided by the total weight of the weld metal. For example, if we have a dilution of 0.40, the fraction of the weld metal that came from the consumable electrode is 0.60.
Fluorescein aqueous solutions, diluted from 10 000 to 1 part per million in intervals of ten-fold dilution. At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow.
Air pollutant concentrations, as measured or as calculated by air pollution dispersion modeling, [1] must often be converted or corrected to be expressed as required by the regulations issued by various governmental agencies.
Adding of an isotopically altered standard to the sample changes the natural isotopic composition of the analyte. By measuring the resulting isotopic composition, it is possible to calculate the amount of the analyte present in the sample. Isotope dilution analysis is a method of determining the quantity of chemical substances. In its most ...