Search results
Results from the WOW.Com Content Network
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the network uses the same gateway. The gateway should have a static address, as changing the address would cause packets not to be delivered. The gateway is typically assigned either the highest or lowest network ...
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6 , the default route is specified by :: / 0 . The subnet mask is specified as / 0 , which effectively specifies all networks and is the shortest match possible.
A first hop redundancy protocol (FHRP) is a computer networking protocol which is designed to protect the default gateway used on a subnetwork by allowing two or more routers to provide backup for that address; [1] [2] in the event of failure of an active router, the backup router will take over the address, usually within a few seconds.
On Windows XP, the server, by default, gets the IP address 192.168.0.1. (This default can be changed within the interface settings of the network adapter or in the Windows Registry .) It provides NAT services to the entire 192.168.0.x subnet, even if the address on the client was set manually, not by the DHCP server.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
The primary router with the highest configured priority will act as a virtual router with a pre-defined gateway IP address and will respond to the ARP or ND request from machines connected to the LAN with a virtual MAC address. If the primary router should fail, the router with the next-highest priority would take over the gateway IP address ...
Microsoft Forefront Threat Management Gateway 2010 (Forefront TMG 2010) was released on 17 November 2009. [16] It is built on the foundation of ISA Server 2006 and provides enhanced web protection, native 64-bit support, support for Windows Server 2008 and Windows Server 2008 R2, malware protection and BITS caching.