Search results
Results from the WOW.Com Content Network
The memory cell is the fundamental building block of computer memory. The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 (high voltage level) and reset to store a logic 0 (low voltage level). Its value is maintained/stored until it is changed by the set/reset process.
Dynamic random-access memory (dynamic RAM or DRAM) is a type of random-access semiconductor memory that stores each bit of data in a memory cell, usually consisting of a tiny capacitor and a transistor, both typically based on metal–oxide–semiconductor (MOS) technology. While most DRAM memory cell designs use a capacitor and transistor ...
Memory modules of SK Hynix. In computing, a memory module or RAM stick is a printed circuit board on which memory integrated circuits are mounted. [1] Memory modules permit easy installation and replacement in electronic systems, especially computers such as personal computers, workstations, and servers. The first memory modules were ...
Memory cells that use fewer than four transistors are possible; however, such 3T [27] [28] or 1T cells are DRAM, not SRAM (even the so-called 1T-SRAM). Access to the cell is enabled by the word line (WL in figure) which controls the two access transistors M 5 and M 6 which, in turn, control whether the cell should be connected to the bit lines ...
Toggle Science and technology subsection. 9.1 Computing. 9.2 Military. ... Ram, ram, or RAM most commonly refers to: A male sheep; Random-access memory, computer memory;
The memory is divided into several equally sized but independent sections called banks, allowing the device to operate on a memory access command in each bank simultaneously and speed up access in an interleaved fashion. This allows SDRAMs to achieve greater concurrency and higher data transfer rates than asynchronous DRAMs could.
A DIMM (Dual In-Line Memory Module) is a popular type of memory module used in computers. It is a printed circuit board with one or both sides (front and back) holding DRAM chips and pins . [ 1 ] The vast majority of DIMMs are manufactured in compliance with JEDEC memory standards , although there are proprietary DIMMs.
The design of many common Rambus memory controllers dictated that memory modules be installed in sets of two. Any remaining open memory slots must be filled with continuity RIMMs (CRIMMs). These modules provide no extra memory and only served to propagate the signal to termination resistors on the motherboard instead of providing a dead end ...