Search results
Results from the WOW.Com Content Network
A soldering station is a multipurpose power soldering device designed for electronic components soldering. This type of equipment is mostly used in electronics and electrical engineering . Soldering station consists of one or more soldering tools connected to the main unit, which includes the controls (temperature adjustment), means of ...
Anything with a base unit with provision to maintain a stable temperature, pump air in either direction, etc., is often called a "station" (preceded by rework, soldering, desoldering, hot air); one, or sometimes more, tools may be connected to a station, e.g., a rework station may accommodate a soldering iron and hot air head. A soldering iron ...
A gun may include a two-stage trigger to give two heat settings. Tips designed for cutting and shaping plastic are available; soldering guns for general home use may be supplied with a kit of different tips. The temperature of the soldering tip is regulated manually by holding the button until the solder melts, and then releasing it.
Hand soldering is typically performed with a soldering iron, soldering gun, or a torch, or occasionally a hot-air pencil. Sheetmetal work was traditionally done with "soldering coppers" directly heated by a flame, with sufficient stored heat in the mass of the soldering copper to complete a joint; gas torches (e.g. butane or propane) or ...
Electric soldering iron A gas-fired soldering iron. A soldering iron is a hand tool used in soldering. It supplies heat to melt solder so that it can flow into the joint between two workpieces. A soldering iron is composed of a heated metal tip (the bit) and an insulated handle.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Compressed air is universally used where there is a possibility of fuel or vapor ignition - such as automotive workshops. Professional level electric tools differ from DIY or 'consumer' tools by being double insulated and not earthed - in fact, they must not be earthed for safety reasons.
By 1935, Milwaukee Electric Tool Corporation developed a lightweight 3/4" electric hammer drill. This power tool was designed to drill and sink anchors into concrete. This drill could also be converted into a standard 3/4" drill. Milwaukee also designed an easy-to-handle, single-horsepower sander/grinder that weighed only 15 pounds. [7]