Ads
related to: 3.6 mm conversion kit for small block truck headers and fullwalmart.com has been visited by 1M+ users in the past month
temu.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
A 289 Ford small-block V8 in a 1965 Ford Mustang. The 289 cu in (4.7 L) V8 was introduced in April 1963, carrying the Challenger name over from the 260 [3] and replacing it as the base V8 for full-sized Fords. Bore was expanded to 4.00 in (101.6 mm), becoming the standard for most small block Ford engines. Stroke remained at 2.87 inches.
A 254 cu in (4.2 L) version of the L-6 (designated the M-series or Rouge 254) was used from 1950 to 1953 in F6-series Ford trucks (COE, dump, truck-tractor, etc.), and small Ford school buses. The M-series engine produced 115 hp (86 kW) and 212 lb⋅ft (287 N⋅m) of torque.
The LY6 is a Generation IV small-block V8 truck engine with a cast-iron block. It shares the same bore and stroke as its LQ4 predecessor. Like other Gen IV engines, it features variable valve timing. It generated 361 hp (269 kW) at 5,600 rpm and 385 lb⋅ft (522 N⋅m) of torque at 4,400 rpm using "regular" gas, or ~87 octane.
The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88.9 mm), shared with the 200 V6 introduced a year earlier. It was only available with a M2ME Rochester Dualjet 210–effectively a Rochester Quadrajet with no rear barrels.
During the 1990s, the Ford V8 that was used in these trucks was decommissioned and removed for more economical Renault engines to be retrofitted. Thus the Ford V8 engines were sold off and thus provided a new source of little-worn engines for the hotrodding community. The block metallurgy, being much later, was also stronger than the originals ...
Ads
related to: 3.6 mm conversion kit for small block truck headers and fullwalmart.com has been visited by 1M+ users in the past month
temu.com has been visited by 1M+ users in the past month