enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Current sensing - Wikipedia

   en.wikipedia.org/wiki/Current_sensing

   The sensed current and the output signal can be: Alternating current input, analog output, which duplicates the wave shape of the sensed current. bipolar output, which duplicates the wave shape of the sensed current. unipolar output, which is proportional to the average or RMS value of the sensed current. Direct current input,

3. Current sense amplifier - Wikipedia

   en.wikipedia.org/wiki/Current_sense_amplifier

   They utilize a "current-sense resistor" to convert the load current in the power rail to a small voltage, which is then amplified by the current-sense amplifiers. The currents in the power rail can be in the range of 1 A to 20 A, requiring the current-sense resistor to be a resistor typically in the range of 1 to 100 mΩ.

4. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   10 +12 V1 DC Voltage Sensing Pin ... for a current-limited bench laboratory DC ... output for 100 microseconds. The -12V supply is now specified as optional on the ...

5. Sense (electronics) - Wikipedia

   en.wikipedia.org/wiki/Sense_(electronics)

   In electronics, sense is a technique used in power supplies to produce the correct voltage for a load.Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output and its actual output.

6. Electronic symbol - Wikipedia

   en.wikipedia.org/wiki/Electronic_symbol

   Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...

7. Chopper (electronics) - Wikipedia

   en.wikipedia.org/wiki/Chopper_(electronics)

   For all the chopper configurations operating from a fixed DC input voltage, the average value of the output voltage is controlled by periodic opening and closing of the switches used in the chopper circuit. The average output voltage can be controlled by different techniques namely: Pulse-width modulation; Frequency modulation