Ads
related to: fishplate rail connectors electrical supply systemebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A fishplate joins two lengths of track. A fishplate, splice bar or joint bar is a metal connecting plate used to bolt the ends of two rails into a continuous track. The name is derived from fish, [1] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [2] The top and bottom faces taper inwards along ...
An overhead line consists of one or more wires (or rails, particularly in tunnels) situated over rail tracks, raised to a high electrical potential by connection to feeder stations at regularly spaced intervals along the track. The feeder stations are usually fed from a high-voltage electrical grid.
An interlocking system is designed so that it is impossible to display a signal to proceed unless the route to be used is proven safe. Interlocking is a safety measure designed to prevent signals and points/switches from being changed in an improper sequence. For example, interlocking would prevent a signal from being changed to indicate a ...
This is a list of the power supply systems that are, or have been, used for railway electrification. Note that the voltages are nominal and vary depending on load and distance from the substation. As of 2023 many trams and trains use on-board solid-state electronics to convert these supplies to run three-phase AC traction motors.
The 2 × 25 kV autotransformer system is a split-phase electric power system which supplies 25 kV power to the trains, but transmits power at 50 kV to reduce energy losses. It should not be confused with the 50 kV system. In this system, the current is mainly carried between the overhead line and a feeder transmission line instead of the rail.
Railway electrification is the use of electric power for the propulsion of rail transport. Electric railways use either electric locomotives (hauling passengers or freight in separate cars), electric multiple units (passenger cars with their own motors) or both. Electricity is typically generated in large and relatively efficient generating ...
Transposition pylon of power line for single-phase AC traction current (110 kV, 16.7 Hz) near Bartholomä in Germany. A traction network or traction power network is an electricity grid for the supply of electrified rail networks. The installation of a separate traction network generally is done only if the railway in question uses alternating ...
Current collector. A current collector (often called a "pickup") is a device used in trolleybuses, trams, electric locomotives and EMUs to carry electric power (current) from overhead lines, electric third rails, or ground-level power supplies to the electrical equipment of the vehicles. Those for overhead wires are roof-mounted devices, those ...
Ads
related to: fishplate rail connectors electrical supply systemebay.com has been visited by 1M+ users in the past month