enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Coupon (PWB) - Wikipedia

   en.wikipedia.org/wiki/Coupon_(PWB)

   A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...

3. Printed circuit board manufacturing - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board...

   Printed circuit board manufacturing is the process of manufacturing bare printed circuit boards (PCBs) and populating them with electronic components. It involves the full assembly of a board into a functional circuit board. In board manufacturing, multiple PCBs are grouped on a single panel for efficient processing.

4. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the through-hole paths to the other surface, and ...

5. PCB-Investigator - Wikipedia

   en.wikipedia.org/wiki/PCB-Investigator

   PCB-Investigator is a software tool used for the analysis, visualization, and optimization of printed circuit boards (PCBs). It is used for tasks such as PCB design validation and quality assurance. It is developed by EasyLogix [1] owned by Schindler & Schill GmbH, a German company specializing in electronic design automation (EDA) software.

6. Rework (electronics) - Wikipedia

   en.wikipedia.org/wiki/Rework_(electronics)

   Reflowing as a rework technique, similar to the manufacturing process of reflow soldering, involves dismantling the equipment to remove the faulty circuit board, pre-heating the whole board in an oven, heating the non-functioning component further to melt the solder, then cooling, following a carefully determined thermal profile, and ...

7. In-circuit testing - Wikipedia

   en.wikipedia.org/wiki/In-circuit_testing

   A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.