Search results
Results from the WOW.Com Content Network
An elaborate Celtic scabbard of 1-200 AD, in two colours of bronze 1916 Leather Scabbard for a saddle lever-action rifle of Jack Peters, a ranch hand that worked on the Grant-Kohrs Ranch, in Powell County, Montana. A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons.
The brass cases had a paper patch in the base, to prevent powder seepage and still allow the cap to fire the round. The weapon was 0.525 in (13.3 mm) caliber with a 22 in (56 cm) barrel. The rifle was strongly made, but unpopular with troops. Frequently, the cases stuck due to expansion of the front part and had to be laboriously removed.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
A 12-gauge shotgun cartridge in a transparent plastic hull, allowing the contents to be seen. From left to right: brass, propellant, over-powder wad, shot wad, #8 birdshot, over-shot wad, and crimp. A shotgun cartridge, shotshell, or shell is a type of rimmed, cylindrical (straight-walled) ammunition used specifically in shotguns.
Lead bullet being supported by a wooden cup sabot in a Delvigne gun. A cup sabot supports the base and rear end of a projectile, and the cup material alone can provide both structural support and barrel obturation. When the sabot and projectile exit the muzzle of the gun, air pressure alone on the sabot forces the sabot to release the projectile.
The canister round is known as a case, so canister was sometimes called case shot and the term has confusingly become generic for grapeshot and shrapnel shells. [1] However, the term case shot is also used to describe a hollow ball containing a powder charge and bullets. After firing the iron ball the powder would explode, scattering the bullets.
The user kept his shot in a leather pouch and his powder in a flask with a volumetric spout. The spout was calibrated to deliver the proper charge for the user's arquebus. With the advent of the heavy arquebus (later known as a musket) in the early 16th century, a spout large enough to measure the required powder was impractical. Furthermore ...
The first references to the possible use of polymers in the manufacture of casings come from the early 1950s. One of the earliest is the patent filed by Jack W. Roske in 1950 [1] and the idea was to use a metal cup joined with a polymer shell "that will be converted to gas during the firing phase to assist in propelling the projectile and thereby permit reduction in the use of the propelling ...