enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...

3. Chilled beam - Wikipedia

   en.wikipedia.org/wiki/Chilled_beam

   A chilled beam is a type of radiation/convection HVAC system designed to heat and cool large buildings through the use of water. [1] This method removes most of the zone sensible local heat gains and allows the flow rate of pre-conditioned air from the air handling unit to be reduced, lowering by 60% to 80% the ducted design airflow rate and the equipment capacity requirements.

4. Diffuser (thermodynamics) - Wikipedia

   en.wikipedia.org/wiki/Diffuser_(thermodynamics)

   Ducts containing fluids flowing at low velocity can usually be analyzed using Bernoulli's principle. Analyzing ducts flowing at higher velocities with Mach numbers in excess of 0.3 usually require compressible flow relations. [2] A typical subsonic diffuser is a duct that increases in area in the direction of flow. As the area increases, fluid ...

5. Air handler - Wikipedia

   en.wikipedia.org/wiki/Air_handler

   1 – Supply duct 2 – Fan compartment 3 – Vibration isolator ('flex joint') 4 – Heating and/or cooling coil 5 – Filter compartment 6 – Mixed (recirculated + outside) air duct A rooftop packaged unit or RTU

6. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Duct dead loads: are often simplified (in Cement plant usage) by using duct plate weight, multiplied by 1.15 as a stiffener allowance, as duct stiffeners usually weigh less than 15% times the duct plate weight. Duct stiffener allowance for rectangular power plants ductwork may be 50% to 100% of the duct plate weight.

7. Fan coil unit - Wikipedia

   en.wikipedia.org/wiki/Fan_coil_unit

   Four-pipe fan coil units have two supply pipes and two return pipes. This allows either hot or cold water to enter the unit at any given time. Since it is often necessary to heat and cool different areas of a building at the same time, due to differences in internal heat loss or heat gains, the four-pipe fan coil unit is most commonly used.