Ad
related to: dodge frogwheeler rear end identification 10 bolt diagram parts
Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60. The majority of the Dana ...
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
The Dana 44 has seen use in Chevrolet Corvettes and Dodge Vipers. This axle is referred to as a Dana 44 ICA or Dana 44 IRS. All 1980–1982 Chevrolet Corvette C3 and manual transmission equipped 1985–1996 Chevrolet Corvette C4 had this axle. The 2005–06 Pontiac GTO, The Dodge Viper has always used a Dana 44 IRS setup.
However, the 10.5" 14-bolt axle remains in production today, specifically utilized in GMC Savana and Chevrolet Express vans. Notably, the 11.5" 14-bolt axle is featured in third-generation Dodge Ram 2500 and 3500 trucks. There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs.
REQUIRED READING: Texas football: QB Quinn Ewers addresses report about a $6 million offer to transfer Ewers has been the Longhorns’ starter each of the past three seasons and has another season ...
WASHINGTON − Former President Bill Clinton was hospitalized in Washington “for testing and observation after developing a fever,” his deputy chief of staff announced Monday. “He remains in ...
The M600 was offered with the Rockwell F-130-NX rear axle, with a 4.88:1 gear ratio. By 1979, Chrysler Corporation no longer sold incomplete chassis and ended production of the M series. The M series was available with three engines during its production: The 318 polysphere Chrysler A engine , the 413 cid, and the 440 cid Chrysler RB engine .
Ad
related to: dodge frogwheeler rear end identification 10 bolt diagram parts