Search results
Results from the WOW.Com Content Network
Weber Inc. is an American manufacturer of charcoal, gas, and electric outdoor grills with related accessories.It also owns restaurants and publishes cookbooks. The company was family owned until it sold a majority stake to BDT Capital Partners in 2010. [1]
One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame.
It is designed to operate before the detonation wave makes it from the hose side to the supply side. Between the regulator and hose, and ideally between hose and torch on both oxygen and fuel lines, a flashback arrestor and/or non-return valve (check valve) should be installed to prevent flame or oxygen-fuel mixture being pushed back into ...
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...
Mud Gas Separator is commonly called a gas-buster or poor boy degasser. It captures and separates the large volumes of free gas within the drilling fluid. If there is a "kick" situation, this vessel separates the mud and the gas by allowing it to flow over baffle plates. The gas then is forced to flow through a line, venting to a flare.
The company was established as Fabbrica Italiana Carburatori Weber in 1923 when Weber produced carburetors as part of a conversion kit for Fiats. Weber pioneered the use of two-stage twin-barrel carburetors, with two venturis of different sizes (the smaller one for low-speed/rpm running and the larger one optimised for high-speed/rpm use).