Search results
Results from the WOW.Com Content Network
A crocodile clip or alligator clip [1] is a plier-like spring-tensioned metal clip with elongated, serrated jaws that is used for creating a temporary electrical connection. This simple mechanical device gets its name from the resemblance of its serrated jaws to the toothed jaws of a crocodile or alligator .
The motor may be diesel or diesel-electric. Depending on the shaft arrangement, mechanical azimuth thrusters are divided into L-drive and Z-drive. An L-drive thruster has a vertical input shaft and a horizontal output shaft with one right-angle gear.
On most modern vessels with direct combustion engines or electric propulsors, the main control handle on the bridge acts as a direct throttle with no intervening engine room personnel. As such, it is regarded under the rules of marine classification societies as a remote control device rather than an EOT, though it is still often referred to by ...
The torpedo stern or torpedo-boat stern describes a kind of stern with a low rounded shape that is nearly flat at the waterline, but which then slopes upward in a conical fashion towards the deck (practical for small high-speed power boats with very shallow drafts). [12] A Costanzi stern is a type of stern designed for use on ocean-going vessels.
With both inboards and stern drives there is a fire and explosion hazard from gasoline fuel vapors within the engine compartment. Typically these boats must run a blower for several minutes prior to starting the engine, and when idling or moving below cruise speed. The blower exchanges the air within the engine compartment with fresh outside air.
It does not refer to an electric motor in a rotating pod. The device is different from the Voith-Schneider marine propulsion system (also mechanically linked), which can also quickly change the direction of thrust, as the Z-drive uses a shrouded conventional screw that pivots or rotates the propeller, unlike the variable-geometry blades of the ...
A cable layer or cable ship is a deep-sea vessel designed and used to lay underwater cables for telecommunications, for electric power transmission, military, or other purposes. Cable ships are distinguished by large cable sheaves [1] for guiding cable over bow or stern or both.
Watercraft navigation lights must permit other vessels to determine the type and relative angle of a vessel, and thus decide if there is a danger of collision. In general, sailing vessels are required to carry a green light that shines from dead ahead to 2 points (22 + 1 ⁄ 2 °) abaft [note 1] the beam on the starboard side (the right side from the perspective of someone on board facing ...