Search results
Results from the WOW.Com Content Network
Due to typical file system design, the amount of space allocated for a file is usually larger than the size of the file's data – resulting in a relatively small amount of unusable storage space for each file, called slack space or internal fragmentation.
In this convention, one thousand and twenty-four megabytes (1024 MB) is equal to one gigabyte (1 GB), where 1 GB is 1024 3 bytes (i.e., 1 GiB). Mixed 1 MB = 1 024 000 bytes (= 1000×1024 B) is the definition used to describe the formatted capacity of the 1.44 MB 3.5-inch HD floppy disk , which actually has a capacity of 1 474 560 bytes .
Memory bandwidth is the rate at which data can be read from or stored into a semiconductor memory by a processor.Memory bandwidth is usually expressed in units of bytes/second, though this can vary for systems with natural data sizes that are not a multiple of the commonly used 8-bit bytes.
3 MB: A three-minute song (133 kbit/s) 650–900 MB – a CD-ROM; 1 GB: 114 minutes of uncompressed CD-quality audio at 1.4 Mbit/s; 16 GB: DDR5 DRAM laptop memory under $40 (as of early 2024) 32/64/128 GB: Three common sizes of USB flash drives; 1 TB: The size of a $30 hard disk (as of early 2024)
Thus, a representation that compresses the storage size of a file from 10 MB to 2 MB yields a space saving of 1 - 2/10 = 0.8, often notated as a percentage, 80%. For signals of indefinite size, such as streaming audio and video, the compression ratio is defined in terms of uncompressed and compressed data rates instead of data sizes:
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B/s, i.e. 8 GB/s, or approximately 7.45 GiB/s
Density is a measure of the quantity of information bits that can be stored on a given physical space of a computer storage medium.There are three types of density: length (linear density) of track, area of the surface (areal density), or in a given volume (volumetric density).
A word is a fixed-sized datum handled as a unit by the instruction set or the hardware of the processor. The number of bits or digits [a] in a word (the word size, word width, or word length) is an important characteristic of any specific processor design or computer architecture.