Search results
Results from the WOW.Com Content Network
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
Corner reflector UHF TV antenna from 1954 with bowtie dipole driven element. A corner reflector antenna is a type of directional antenna used at VHF and UHF frequencies. [1] [2] It was invented by John D. Kraus in 1938. [3] [4] It consists of a dipole driven element mounted in front of two flat rectangular reflecting screens joined at an angle ...
The discone antenna has a useful frequency range of at least 10 to 1. [2] [3] When employed as a transmitting antenna, a properly constructed discone is just as efficient as an antenna designed for a more limited frequency range. The extra bandwidth comes from the controlled taper and large termination radius of the cone.
Vertically polarized outgoing radiation is important for long-distance transmissions in the mediumwaves and lower: The ground waves that carry radio signals at frequencies below about 2 MHz must be vertically polarized to reduce signal absorption by the Earth. [2] Large vertical monopole antennas are used for broadcasting in the lower half of ...
The gain and input impedance of the antenna is dependent on the length of the whip element, compared to a wavelength, but also on the size and shape of the ground plane used (if any). A quarter wave vertical antenna working against a perfectly conducting, infinite ground will have a gain of 5.19 dBi and a radiation resistance of about 36.8 ohms.
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
An inverted vee antenna is a type of antenna similar to a horizontal dipole, but with the two sides bent down towards the ground, typically creating a 120- or 90-degree angle between the dipole legs. It is typically used in areas of limited space as it can significantly reduce the ground foot print of the antenna without significantly impacting ...
The horizontal gain continues to increase up to a maximum of about 6.6 dBi at a length of five-eighths wavelength 5 / 8 λ so this is a popular length for ground wave antennas and terrestrial communication antennas, for frequencies where a larger antenna size is feasible. The input impedance drops to about 40 Ohms at that length.