enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

3. Hydraulic machinery - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_machinery

   The tubes are supplied by manufacturers in lengths of 6 m, cleaned, oiled and plugged. The tubes are interconnected by different types of flanges (especially for the larger sizes and pressures), welding cones/nipples (with o-ring seal), several types of flare connection and by cut-rings. In larger sizes, hydraulic pipes are used.

4. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.

5. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Copper tubing is most often used for supply of hot and cold water, and as refrigerant line in HVAC systems. There are two basic types of copper tubing, soft copper and rigid copper. Copper tubing is joined using flare connection, compression connection, or solder. Copper offers a high level of resistance to corrosion, but is becoming very costly.

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The welding of metals differs from soldering and brazing in that the joint is made without adding a lower-melting-point material (e.g. solder); instead, the pipe or tubing material is partially melted, and the fitting and piping are directly fused. This generally requires piping and fitting to be the same (or compatible) material.

7. Puppy Only Wants to Be Held? Here's What to Do - AOL

   www.aol.com/puppy-only-wants-held-heres...

   4. Make Training Fun. For puppies of this age, training should be short and sweet, just 1 to 2 minutes max, and it should be very low-pressure: Smile as you train and make it fun.