Search results
Results from the WOW.Com Content Network
Boundary microphone (Audio-Technica ATM87R) A boundary microphone (or pressure zone microphone) is one or more small omnidirectional or cardioid condenser mic capsule(s) positioned near or flush with a boundary (surface) such as a floor, table, or wall. The capsule(s) is/are typically mounted in a flat plate or housing.
Audio-Technica; Behringer; Beyerdynamic; Blue Microphones; ... The following is a list of defunct microphone manufacturers with articles. Aiwa; Altec Lansing ...
Technics (テクニクス, Tekunikusu) is a Japanese audio brand established by Matsushita Electric (now Panasonic) in 1965.Since 1965, Matsushita has produced a variety of HiFi and other audio products under the brand name, such as turntables, amplifiers, radio receivers, tape recorders, CD players, loudspeakers, and digital pianos.
The condenser microphone, invented at Western Electric in 1916 by E. C. Wente, [22] is also called a capacitor microphone or electrostatic microphone—capacitors were historically called condensers. The diaphragm acts as one plate of a capacitor, and audio vibrations produce changes in the distance between the plates.
Microphone diaphragms, unlike speaker diaphragms, tend to be thin and flexible, since they need to absorb as much sound as possible. In a condenser microphone, the diaphragm is placed in front of a plate and is charged. [2] In a dynamic microphone, the diaphragm is glued to a magnetic coil, similar to the one in a dynamic loudspeaker.
A lavalier microphone mounted on a T-shirt. A lavalier microphone or lavalier (also known as a lav, lapel mic, clip mic, body mic, collar mic, neck mic or personal mic) is a small microphone used for television, theater, and public speaking applications to allow hands-free operation.
Surround microphone techniques largely depend on the setup used, therefore being biased towards the 5.1 surround setup, as this is the standard. [24] Surround recording techniques can be differentiated into those that use single arrays of microphones placed in close proximity, and those treating front and rear channels with separate arrays.
Electret microphone capsules This typical electret microphone circuit has a common source configured JFET inside the two-terminal electret capsule. The JFET is externally-powered by the DC voltage V + through a resistor which sets the gain and output impedance. The output audio signal is received though a DC blocking capacitor.