enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. String trimmer - Wikipedia

   en.wikipedia.org/wiki/String_trimmer

   At this size they can easily turn 2-millimetre (0.079 in) line and some have nylon blades as accessories to the line-reel. A 32 cc (32 cm 3; 2.0 cu in) engine can swing a 2.75 mm (0.108 in) line and often has metal-blade accessories.

3. Edger - Wikipedia

   en.wikipedia.org/wiki/Edger

   An edge trimmer or lawn edger is a garden tool, either manual or motorised, [1] to form distinct boundaries between a lawn, typically consisting of a grass, or other soft botanical ground cover, and another ground surface feature such as a paved, concreted or asphalted area, or a granular material such as sand or gravel, or simply uncovered soil, for example an unbounded garden.

4. Brushcutter (garden tool) - Wikipedia

   en.wikipedia.org/wiki/Brushcutter_(garden_tool)

   To use, the handlebars are rotated and the red blade guard removed. Handles vary on brush cutters, depending on the weight and size of the unit. Larger, more powerful brushcutters employ handlebars — a handle on either side of the shaft, similar to bike handlebars — whilst smaller units use a D-shaped handle mounted on the shaft.

5. Boring (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Boring_(manufacturing)

   A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

7. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   After joining the halves, the assembled case may then be line bored (using what is in effect a large diameter reamer), and then disassembled for placement of bearings and other parts. The use of reamed dowel holes is typical in any machine design, where any two locating parts have to be located and mated accurately to one another - typically as ...

8. Lumber edger - Wikipedia

   en.wikipedia.org/wiki/Lumber_edger

   A lumber edger is a device with saws used to straighten and smooth rough lumber or bowed stock by making a cut along the sides of the boards. The result of this process is dimensional lumber. [1] [2] In a saw mill the edger is next in line from the head saw. The feed and press rollers on the edger are usually powered, passing the lumber through ...

9. Bore gauge - Wikipedia

   en.wikipedia.org/wiki/Bore_gauge

   Small-hole gauge set. Sizes from top to bottom: 3 to 5 mm (0.118 to 0.197 in) 5 to 7.5 mm (0.197 to 0.295 in) 7.5 to 10 mm (0.295 to 0.394 in) 10 to 13 mm (0.394 to 0.512 in) Small-hole gauges require a slightly different technique to the telescopic gauges, the small hole gauge is initially set smaller than the bore to be measured.