Search results
Results from the WOW.Com Content Network
/ = the fore of the rear axles is steered (pusher axle) * = the rearmost of the rear axles is steered (tag axle) C = number of steered wheels - = separates axle groups and/or different axle functions (6x4-2 is 6x6 with undriven rear axle) Basis is always the standard configuration, meaning a steered front axle and a non-steered driven rear axle.
The first Dana 70 axles had a 1 ⁄ 2-inch (13 mm) pinion offset and were found in Dana 70HD's as well. The drawback with the 1 / 2-inch offset was that a 4.10:1 gear ratio was the highest gear set possible. In the 1970s the 1 / 2-inch offset was phased out for a 5 ⁄ 8-inch (16 mm) offset that allowed
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
Trac Loks were a US$350.00 option with Ford Super Duty trucks. [1] The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel
A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a Dana 61, lower gear sets deeper than (4.10:1 on down) are not. Dana 61 diff.case with dual reinforcement ribbing-top Dana 61 diff.case with dual reinforcement ribbing-bottom
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.
Super 8.8. Ford released an updated version in both solid and IRS form for 2015+ Mustangs and F-150. The most apparent difference is a 12 bolt cover instead of the traditional 10. The super 8.8 also uses larger bearings,longer pinion with larger nut, and most significantly 34 spline axles or half shafts.