Search results
Results from the WOW.Com Content Network
The CMS detector is built around a huge solenoid magnet. This takes the form of a cylindrical coil of superconducting cable that generates a magnetic field of 4 tesla, about 100 000 times that of the Earth. The magnetic field is confined by a steel 'yoke' that forms the bulk of the detector's weight at 12,500 t.
The superconducting nanowire single-photon detector (SNSPD or SSPD) is a type of optical and near-infrared single-photon detector based on a current-biased superconducting nanowire. [1] It was first developed by scientists at Moscow State Pedagogical University and at the University of Rochester in 2001.
Husky 2G is a two-seat variant of Husky MK III vehicle mounted mine detector (VMMD) designed and manufactured by South African firm DCD Protected Mobility (DCD PM). Equipped with a number of sensors , the vehicle is ideally suited for mine-clearing operations including detection, identification and destruction of improvised explosive devices ...
Low-background steel, also known as pre-war steel [1] and pre-atomic steel, [2] is any steel produced prior to the detonation of the first nuclear bombs in the 1940s and 1950s. Typically sourced from ships (either as part of regular scrapping or shipwrecks ) and other steel artifacts of this era, it is often used for modern particle detectors ...
Photon counting eliminates gain noise, where the proportionality constant between analog signal out and number of photons varies randomly. Thus, the excess noise factor of a photon-counting detector is unity, and the achievable signal-to-noise ratio for a fixed number of photons is generally higher than the same detector without photon counting.
A semiconductor detector in ionizing radiation detection physics is a device that uses a semiconductor (usually silicon or germanium) to measure the effect of incident charged particles or photons. Semiconductor detectors find broad application for radiation protection, gamma and X-ray spectrometry, and as particle detectors.
An infrared detector is a detector that reacts to infrared (IR) radiation. The two main types of detectors are thermal and photonic ( photodetectors ). The thermal effects of the incident IR radiation can be followed through many temperature dependent phenomena. [ 2 ]
Thor III dismounted CREW system: The Thor III system consists of three dismounted man-pack subsystems, one battery charger, and twenty-four batteries (BB-2590/U). Each subsystem contains a R/T (low band, mid band or high band), a Remote Control Unit (RCU), an integration/pack frame, an Rx/Tx Antenna (low band, mid band, or high band), a GPS ...