Ads
related to: what is a ide drive
Search results
Results from the WOW.Com Content Network
Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.
The drives within an A-unit and all other drives in a string had interfaces similar to the early interfaces, above. A-units connected to IBM Directors or integrated attachments . Small Computer System Interface (SCSI) , originally named SASI for Shugart Associates System Interface, is an early (circa 1978) industry standard interface explicitly ...
Integrated Drive Electronics (IDE), later standardized under the name AT Attachment (ATA, with the alias PATA (Parallel ATA) retroactively added upon introduction of SATA) moved the HDD controller from the interface card to the disk drive. This helped to standardize the host/controller interface, reduce the programming complexity in the host ...
The format was standardized as EIA-741 and co-published as SFF-8501 for disk drives, with other SFF-85xx series standards covering related 5.25 inch devices (optical drives, etc.) [33] The Quantum Bigfoot HDD was the last to use it in the late 1990s, with "low-profile" (≈25 mm) and "ultra-low-profile" (≈20 mm) high versions.
ATAPI (ATA Packet Interface) is a protocol used with the Parallel ATA (IDE) and Serial ATA standards so that a greater variety of devices can be connected to a computer than with the ATA command set alone.
A disk array controller is a device that manages the physical disk drives and presents them to the computer as logical units. It often implements hardware RAID, thus it is sometimes referred to as RAID controller. It also often provides additional disk cache.
A Parallel ATA (aka IDE) hard drive interface supports two hard drives on a cable, which are designated master and slave. The distinction is required by the interface even though neither drive has control or priority over the other.
When a SATA controller is configured to operate in IDE Mode, the number of storage devices per controller is usually limited to four (two IDE channels, master device and slave device with up to two devices per channel), compared to the maximum of 32 devices/ports when configured in AHCI mode.
Ads
related to: what is a ide drive