Search results
Results from the WOW.Com Content Network
Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
The cable connecting the receiver to the LNB are of the low loss type RG-6, quad shield RG-6, or RG-11. [22] RG-59 is not recommended for this application as it is not technically designed to carry frequencies above 950 MHz, but will work in many circumstances, depending on the quality of the coaxial wire. [22]
Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using. If you don't have another browser, download a supported one for free. 2. Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything ...
RG stands for Radio Guide, or Radio Grade and is a term that is used when sending Radio Frequency (RF) signals down a coaxial cable. 75 ohm coaxial cable comes in several sizes with the most common types being RG-179, RG-59, and RG-11. An RG-179 & RG-59 cables are the most commonly used coax because they are small in diameter and easy to work with.
10BASE2 uses RG-58A/U cable or similar for a maximum segment length of 185 m as opposed to the thicker RG-8-like cable used in 10BASE5 networks with a maximum length of 500 m. The RG-58 type wire used by 10BASE2 was inexpensive, smaller and much more flexible than the specialized RG-8 variant. 10BASE2 can also use RG-59 cable.
A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.
NEXT is a measure of the ability of a cable to reject crosstalk, so the higher the NEXT value, the greater the rejection of crosstalk at the local connection. It is referred to as near end because the interference between the two signals in the cable is measured at the same end of the cable as the interfering transmitter. The NEXT value for a ...