Search results
Results from the WOW.Com Content Network
A real time clock alarm is a feature that can be used to allow a computer to 'wake up' after shut down to execute tasks every day or on a certain day. It can sometimes be found in the 'Power Management' section of a motherboard's BIOS/UEFI setup. Wake On LAN, Wake on ring, and IPMI functions could also be used to start a computer after it is ...
APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
Active-state power management (ASPM) is a power management mechanism for PCI Express devices to garner power savings while otherwise in a fully active state. Predominantly, this is achieved through active-state link power management; i.e., the PCI Express serial link is powered down when there is no traffic across it.
Wake-on-Ring (WOR) or Wake-on-Modem (WOM) is a specification that allows supported computers and devices to "wake up" or turn on from a sleeping, hibernating or "soft off" state (e.g. ACPI state G1 or G2), and begin operation.
Sleep mode corresponds to ACPI mode S3. When a non-ACPI device is plugged in, Windows will sometimes disable stand-by functionality for the whole operating system. Without ACPI functionality, as seen on older hardware, sleep mode is usually restricted to turning off the monitor and spinning down the hard drive.
Power management is a feature of some electrical appliances, especially copiers, computers, computer CPUs, computer GPUs and computer peripherals such as monitors and printers, that turns off the power or switches the system to a low-power state when inactive.
Wake-on-LAN (WoL or WOL) [a] is an Ethernet or Token Ring computer networking standard that allows a computer to be turned on or awakened from sleep mode by a network message. The message is usually sent to the target computer by a program executed on a device connected to the same local area network (LAN).