Search results
Results from the WOW.Com Content Network
Explosion-proofing designs equipment to contain ignition hazards, prevent entry of hazardous substances, and, contain any fire or explosion that could occur. Different countries have approached the standardization and testing of equipment for hazardous areas in different ways. Terminology for both hazards and protective measures can vary.
This can be achieved by a flameproof enclosure, where the housing is designed to prevent ignition sparks from leaving the housing even if there is an explosion inside. Actuators designed for these applications, being explosion-proof devices, have to be qualified by a test authority (notified body). Explosion protection is not standardized ...
Avoidance makes it impossible for an explosion or deflagration to occur, for instance by means of suppressing the heat and the pressure needed for an explosion using an aluminum mesh structure such as eXess, by means of consistent displacement of the O 2 necessary for an explosion or deflagration to take place, by means of padding gas (f. i. CO 2 or N 2), or, by means of keeping the ...
Manually actuated devices, also known as fire alarm boxes, manual pull stations, or simply pull stations, break glass stations, and (in Europe) call points, are installed to be readily located (usually near the exits of a floor or building), identified, and operated. They are usually actuated using physical interaction, such as pulling a lever ...
Package/enclosure — open, touch-safe, double-voltage for isolation between circuits, explosion proof, outdoor, oil and splash resistant, washable for printed circuit board assembly; Operating environment — minimum and maximum operating temperature and other environmental considerations, such as effects of humidity and salt
Approximately 25 of those cars were so equipped. A large nickel-plated box was attached to the right side of the steering column which housed the push button mechanism. It utilized six buttons – first through third gear, reverse, neutral and park. There was a "signal" button which was the horn.
The trapped workers retreated up a steep section of the culvert. Due to poor visibility, thick smoke, and other fumes, workers with fire extinguishers were unable to reach the fire and it continued to burn. The workers trapped by the fire were uninjured in the explosion and maintained radio contact until 2:45 pm. [6]
A push-button (also spelled pushbutton) or simply button is a simple switch mechanism to control some aspect of a machine or a process. Buttons are typically made out of hard material, usually plastic or metal. [1] The surface is usually flat or shaped to accommodate the human finger or hand, so as to be easily depressed or pushed.