enow.com Web Search

  1. Ads

    related to: brake hose mount tabs

Search results

  1. Results from the WOW.Com Content Network
  2. Banjo fitting - Wikipedia

    en.wikipedia.org/wiki/Banjo_fitting

    Two banjo fittings (upper center of photo) atop automotive brake calipers. The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids ...

  3. Braided stainless steel brake lines - Wikipedia

    en.wikipedia.org/wiki/Braided_stainless_steel...

    Since the ideal brake system would use only hard tubing for its lack of expansion, but some use of flexible hose is required, the ideal compromise is to use a hose type that allows a minimal rate of expansion. Thus the assertion that braided stainless steel hose is superior as compared to a typical rubber hose when used in a hydraulic brake system.

  4. Gladhand connector - Wikipedia

    en.wikipedia.org/wiki/Gladhand_connector

    A gladhand connector or gladhand coupler is an interlocking hose coupling fitted to hoses supplying pressurized air from a tractor unit to air brakes on a semi-trailer, [1] or from a locomotive to railway air brakes on railroad cars. [2] Gladhand connectors resemble a pair of "hands shaking" when interlocked, hence the name. [1]

  5. Steam locomotive components - Wikipedia

    en.wikipedia.org/wiki/Steam_locomotive_components

    Brake hose Hose for conveying force to train brakes by a differential in air pressure. Contains either high-pressure compressed air or air at lower than atmospheric pressure (vacuum), depending on whether the locomotive has an air brake or vacuum brake system.

  6. Hose clamp - Wikipedia

    en.wikipedia.org/wiki/Hose_clamp

    The ends of these protrusions are then bent outwards, and the strip rolled to form a ring, with the protruding tabs intermeshing. To use the clamp, the exposed tabs are pressed towards each other (typically using pliers), increasing the diameter of the ring, and the clamp is slid onto the hose, past the portion that will go onto the barb. The ...

  7. Railway brake - Wikipedia

    en.wikipedia.org/wiki/Railway_brake

    The earliest type of continuous brake was the chain brake [19] which used a chain, running the length of the train, to operate brakes on all vehicles simultaneously. The chain brake was soon superseded by air-operated or vacuum operated brakes. These brakes used hoses connecting all the wagons of a train, so the operator could apply or release ...

  1. Ads

    related to: brake hose mount tabs