Search results
Results from the WOW.Com Content Network
An application example is a room temperature controller connected to a heat recovery unit, which is connected to a boiler. The heat recovery unit is then functioning as gateway. In another possible configuration, a thermostat or room controller is connected to a sequencer with further Opentherm interfaces connected to more than one boiler.
Bake-out, in several areas of technology and fabrication, and in building construction, refers to the process of using high heat temperature (), and possibly vacuum, to remove volatile compounds from materials and objects before placing them into situations where the slow release of the same volatile compounds would contaminate the contents of a container or vessel, spoil a vacuum, or cause ...
Barium iodide is an inorganic compound with the formula BaI 2.The compound exists as an anhydrous and a hydrate (BaI 2 (H 2 O) 2), both of which are white solids.When heated, hydrated barium iodide converts to the anhydrous salt.
The study indicates that stratified buildings tend to overheat or overcool based on the temperature at the thermostat, which tends to be lower than the overall heat energy present in the room. The study also showed that energy waste due to stratification was present at ceiling heights ranging from 20 ft. to 40 ft, and higher ceilings caused ...
The illustration is the interior of a common two wire heat-only household thermostat, used to regulate a gas-fired heater via an electric gas valve. Similar mechanisms may also be used to control oil furnaces, boilers, boiler zone valves , electric attic fans, electric furnaces, electric baseboard heaters, and household appliances such as ...
The boiler will also fire (regardless of thermostat state) when the boiler water temperature goes below a range around the low limit, ensuring that the boiler water temperature remains above a certain point. The low limit is intended for tankless domestic hot water; it ensures that boiler water is always warm enough to heat the domestic hot water.
A water heater that maintains desired temperature by turning the applied power on and off (as opposed to continuously varying electrical voltage or current) based on temperature feedback is an example application of bang–bang control. Although the applied power switches from one discrete state to another, the water temperature will remain ...
If temperatures are below this point, the controls will be corroded by condensation of compounds in the flue gas. Heated air ensures that controls are dry during startup. [3] The pressure drop in the length of air hose connecting the blower to the instrument is important when determining blow output requirements. Some systems have one blower ...