enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Rift sawing - Wikipedia

    en.wikipedia.org/wiki/Rift_sawing

    Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.

  3. Shooting board - Wikipedia

    en.wikipedia.org/wiki/Shooting_board

    A shooting board consists of a flat board, the base, with a stop at one end, similar to a bench hook, on which the board to be planed is rested. The stop prevents the board from sliding as it is planed. Parallel to the base and slightly lower is a secondary surface, the fence, which may be a separate board, or may be a rabbet cut into the base ...

  4. Foamcore - Wikipedia

    en.wikipedia.org/wiki/Foamcore

    Foamcore, foam board, or paper-faced foam board is a lightweight and easily cut material used for mounting of photographic prints, as backing for picture framing, for making scale models, and in painting. It consists of a board of polystyrene foam clad with an outer facing of paper on either side, typically white clay-coated paper or brown ...

  5. Owens Corning - Wikipedia

    en.wikipedia.org/wiki/Owens_Corning

    Warship insulation, called Navy Board, was a permanent form-board insulation covered with woven continuous fiber cloth. Owens-Corning produced a prototype boat hull constructed of fiber glass-reinforced plastic in 1944. [11] In 1945, the company worked with an automaker to produce the first fiberglas-reinforced plastic car body.

  6. Blanking and piercing - Wikipedia

    en.wikipedia.org/wiki/Blanking_and_piercing

    The cut made in lancing is not a closed cut, like in perforation even though a similar machine is used, but a side is left connected to be bent sharply or in more of a rounded manner. [citation needed] Lancing can be used to make partial contours and free up material for other operations further down the production line.

  7. NXP LPC - Wikipedia

    en.wikipedia.org/wiki/NXP_LPC

    On-board LPC-LINK for programming and debugging via a MiniUSB connector. Board can be cut into two separate boards: LPC-LINK board and target microcontroller board. Power input from 5 V via the USB cable or 5 V external power. If boards are separated, then 3.3 V external power is required for the target microcontroller board.

  8. Subsidy Scorecards: Appalachian State University

    projects.huffingtonpost.com/projects/ncaa/...

    SOURCE: Integrated Postsecondary Education Data System, Appalachian State University (2014, 2013, 2012, 2011, 2010).Read our methodology here.. HuffPost and The Chronicle examined 201 public D-I schools from 2010-2014.

  9. LosslessCut - Wikipedia

    en.wikipedia.org/wiki/LosslessCut

    This limitation is by design to allow the cutting to be lossless, i.e. without re-encoding the frames adjacent to a cut for the codecs using interframe Motion compensation. [16] Though "smart cut", a feature allowing lossless encoding up to the nearest previous keyframe, then encoding the latter part at a cost of small loss, is available ...