Search results
Results from the WOW.Com Content Network
This SVG diagram contains embedded raster graphics. Such images are liable to produce inferior results when scaled to different sizes (as well as possibly being very inefficient in file size). If appropriate to do so, they should be replaced with images created using vector graphics .
Two-gauge pressure regulator connected to gas cylinder used for breathing gas supply. Pressure regulators are used with diving cylinders for Scuba diving. The tank may contain pressures in excess of 3,000 pounds per square inch (210 bar), which could cause a fatal barotrauma injury to a person breathing it directly. A demand controlled ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A gasoline pump or fuel dispenser is a machine at a filling station that is used to pump gasoline (petrol), diesel, or other types of liquid fuel into vehicles. Gasoline pumps are also known as bowsers or petrol bowsers (in Australia and South Africa), [2] [3] petrol pumps (in Commonwealth countries), or gas pumps (in North America).
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Drawing of a centrifugal "fly-ball" governor. The balls swing out as speed increases, which closes the valve, until a balance is achieved between demand and the proportional gain of the linkage and valve.
This was constructed by the Humphrey Gas Pump Co. of Syracuse, NY, who had licensed the Humphrey patents. [5] A single Humphrey pump was installed at a Sewage works in Southend-on-Sea, England during 1914. The pump had head of 65 ft at a capacity of 198,000 gallons per day. Construction works started for a second pump but was cancelled in 1915. [5]
A needle valve has a relatively small orifice with a long, tapered seat, and a needle-shaped plunger on the end of a screw, which exactly fits the seat. As the screw is turned and the plunger retracted, flow between the seat and the plunger is possible; however, until the plunger is completely retracted, the fluid flow is significantly impeded.