Search results
Results from the WOW.Com Content Network
The power supply only provides 12 V voltage output; [13] 5 V, 3.3 V powers, as needed by USB, hard disk drive and other devices, are transformed on the motherboard; and the ATX motherboard connector is reduced from 24-pin to 10-pin.
The power supply would fail to start unless these minimum load requirements were met, but the AT motherboard did not provide much load on the +12 V line. To solve this problem, entry-level IBM AT models that did not have a hard drive were shipped with a 5-ohm, 50-watt resistor connected on the +12 V line of the hard disk power connector.
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
An opened ATX case, front towards right. Components pictured include a microATX motherboard (top), a CPU (beneath the Cooler Master fan), a GPU (middle), and an SSD (right). The power supply is housed in the compartment at bottom. A computer case, also known as a computer chassis, is the enclosure that contains most of the hardware of a ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...
A 20 % shorter variant of the ATX form factor. Compatible with most ATX cases, but has fewer slots than ATX, for a smaller power supply unit. Very popular for desktop and small form factor computers as of 2017. Mini-ATX: AOpen: 2005 150 × 150 mm (5.9 × 5.9 in) Mini-ATX is considerably smaller than Micro-ATX.