Search results
Results from the WOW.Com Content Network
Air abrasion is a dental technique that uses compressed air to propel a thin stream of abrasive particles—often aluminum oxide or silica—through a specialized hand-piece to remove tooth tissue and decay before being suctioned away, similar to sand blasting.
Teeth whitening strips are easy-to-use, peel-and-stick strips that you wear on your teeth for 15 to 30 minutes each day. "Most kits come with a 30-day supply and are relatively easy to use," says ...
Before you start shopping for over-the-counter teeth whitening products, American Dental Association (ADA) spokesperson Matt Messina, DDS, recommends scheduling an appointment with your dentist ...
A common use of temporary dressing occurs if root canal therapy is carried out over more than one appointment. In between each visit, the pulp canal system must be protected from contamination from the oral cavity, and a temporary filling is placed in the access cavity. Examples include: Zinc oxide eugenol—bactericidal, cheap and easy to remove.
This is due to the combination of two active ingredients found in this version of Burow's solution, i.e. aluminum sulfate tetradecahydrate and calcium acetate monohydrate. [ 8 ] [ 9 ] [ 10 ] The solution is used by some to reduce inflammation and potential infection from conditions such as ingrown nails , in a warm water soak.
Intraosseous anaesthetic injection involves the deposition of anaesthetic solution directly into the cancellous alveolar bone adjacent to the apex of the root of the tooth to be anaesthetised through a small hole. Additionally, more complex dental procedures like surgery or endodontic therapy (like root canals) might make use of it.
Tooth whitening or tooth bleaching is the process of lightening the colour of human teeth. [1] Whitening is often desirable when teeth become yellowed over time for a number of reasons, and can be achieved by changing the intrinsic or extrinsic colour of the tooth enamel . [ 2 ]
During atomic layer deposition, a film is grown on a substrate by exposing its surface to alternate gaseous species (typically referred to as precursors or reactants). In contrast to chemical vapor deposition, the precursors are never present simultaneously in the reactor, but they are inserted as a series of sequential, non-overlapping pulses.