enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Strut channel - Wikipedia

   en.wikipedia.org/wiki/Strut_channel

   Strut is normally made of sheet steel, with a zinc coating (), paint, epoxy, powder coat, or other finish.. Strut channel is also manufactured from stainless steel for use where rusting might become a problem (e.g., outdoors, facilities with corrosive materials), from aluminium alloy when weight is an issue or from fiberglass for very corrosive environments.

3. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   An electrical conduit is a tube used to protect and route electrical wiring in a building or structure. Electrical conduit may be made of metal, plastic, fiber, or fired clay. Most conduit is rigid, but flexible conduit is used for some purposes. Conduit is generally installed by electricians at the

4. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe.

5. Cable tray - Wikipedia

   en.wikipedia.org/wiki/Cable_tray

   In the electrical wiring of buildings, a cable tray system is used to support insulated electrical cables used for power distribution, control, and communication. Cable trays are used as an alternative to open wiring or electrical conduit systems, and are commonly used for cable management in commercial and industrial construction.

6. Pipe support - Wikipedia

   en.wikipedia.org/wiki/Pipe_support

   A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation .

7. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Link supports are often "bents", or braced frames down from the duct support ring (frame) to a foundation or support plane. if the bent is long enough, hinges are not required to allow for duct thermal growth. Rod or hanger supports are similar to link supports, but due to the flexibility of the rod supports, that are easier to design and detail.