Search results
Results from the WOW.Com Content Network
Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called yards and their tips, outside the lifts, are called the yardarms. [1] A ship mainly rigged so is called a square ...
A sail plan is a drawing of a sailing craft, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [1] By extension, "sail plan" describes the arrangement of sails on a craft. [2] [3] A sailing craft may be waterborne (a ship or boat), an iceboat, or a sail-powered land vehicle.
Each rig may be described with a sail plan—a drawing of a vessel, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [4] By extension, "sail plan" describes the arrangement of sails on a vessel. [5] [6] A well-designed sail plan should be balanced, requiring only light forces on ...
A full-rigged ship or fully rigged ship is a sailing vessel with a sail plan of three or more masts, all of them square-rigged. [1] Such a vessel is said to have a ship rig or be ship-rigged, with each mast stepped in three segments: lower, top, and topgallant. [2] [3] [4]
Barquentine sail plan. While a full-rigged ship is square-rigged on all three masts, and the barque is square-rigged except for the mizzen-mast, the barquentine extends the principle by making only the foremast square-rigged. [1]
A brig's square-rig also had the advantage over a fore-and-aft–rigged vessel when travelling offshore, in the trade winds, where vessels sailed down wind for extended distances and where "the danger of a sudden jibe was the large schooner-captain's nightmare". [13] This trait later led to the evolution of the barquentine. The need for large ...
Clewlines and buntlines are lines used to handle the sails of a square rigged ship. The leechlines are clearly visible running inwards and upwards from the edges of the sail. The buntlines up the front of the sail can be seen too, but their run to the blocks on the shrouds is obscured because the sail is set on a lifting yard.
Sail shape is usually controlled by lines that pull at the corners of the sail, including the outhaul at the clew and the downhaul at the tack on fore-and-aft rigs. The orientation of sails to the wind is controlled primarily by sheets, [8] but also by braces, which position the yard arms with respect to the wind on square-rigged vessels. [7]