enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think ...

3. Inch - Wikipedia

   en.wikipedia.org/wiki/Inch

   Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

5. Fraction - Wikipedia

   en.wikipedia.org/wiki/Fraction

   Thus, it is often useful to convert repeating decimals into fractions. A conventional way to indicate a repeating decimal is to place a bar (known as a vinculum) over the digits that repeat, for example 0. 789 = 0.789789789... For repeating patterns that begin immediately after the decimal point, the result of the conversion is the fraction ...

6. Thousandth of an inch - Wikipedia

   en.wikipedia.org/wiki/Thousandth_of_an_inch

   A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils). The words are shortened forms of the English and Latin words for "thousand" (mille ...

7. Help:Convert units - Wikipedia

   en.wikipedia.org/wiki/Help:Convert_units

   The hands value has at most one digit after the decimal mark, and has an optional fraction. A precision of 2 assumes |frac=2 (round to nearest 1 ⁄ 2 inch). A precision of 3 or more assumes |frac=4 (round to nearest 1 ⁄ 4 inch).

8. Template:Height - Wikipedia

   en.wikipedia.org/wiki/Template:Height

   For conversion of metric units to feet/inches, the frac parameter can be specified to either show the output inches as decimals (frac=10) or as a vulgar fraction (frac=desired denominator; the default is 2 for halves). The frac parameter is ignored for conversion of feet/inches to metres.

9. Template:Hands - Wikipedia

   en.wikipedia.org/wiki/Template:Hands

   One hand is four inches, and a value of '12.3 hands' represents 12 hands + 3 inches (51 inches). This template converts hands into the equivalent heights in inches and centimetres. Note : with hands, any fractional part (numbers and vulgar fractions after the period) are inches, not a decimal fraction of a hand.