Search results
Results from the WOW.Com Content Network
In the passive transformation (right), point P stays fixed, while the coordinate system rotates counterclockwise by an angle θ about its origin. The coordinates of P ′ after the active transformation relative to the original coordinate system are the same as the coordinates of P relative to the rotated coordinate system.
The contour Γ.. Problem. Find an upper bound for | (+) |, where Γ is the upper half-circle | z | = a with radius a > 1 traversed once in the counterclockwise direction.. Solution. First observe that the length of the path of integration is half the circumference of a circle with radius a, hence
When increases from zero, i.e., assumes positive values, the line evolves into an ellipse that is being traced out in the counterclockwise direction (looking in the direction of the propagating wave); this then corresponds to left-handed elliptical polarization; the semi-major axis is now oriented at an angle .
The equations defining the transformation in two dimensions, which rotates the xy axes counterclockwise through an angle into the x′y′ axes, are derived as follows. In the xy system, let the point P have polar coordinates ( r , α ) {\displaystyle (r,\alpha )} .
The deviation at any point on the elastic curve is positive if the point lies above the tangent, negative if the point is below the tangent; we measured it from left tangent, if θ is counterclockwise direction, the change in slope is positive, negative if θ is clockwise direction. [3]
Kinematics insists that a force (pushing to the right of the instantaneous direction of travel for a counter-clockwise rotation) must be present to cause this curvature, so the rotating observer is forced to invoke a combination of centrifugal and Coriolis forces to provide the net force required to cause the curved trajectory. [citation needed]
As shown in Figure 6, to determine the stress components (,) acting on a plane at an angle counterclockwise to the plane on which acts, we travel an angle in the same counterclockwise direction around the circle from the known stress point (,) to point (,), i.e., an angle between lines ¯ and ¯ in the Mohr circle.
To properly fasten or unfasten a screw, one applies the above rules: if a screw is right-handed, pointing one's right thumb in the direction of the hole and turning in the direction of the right hand's curled fingers (i.e. clockwise) will fasten the screw, while pointing away from the hole and turning in the new direction (i.e. counterclockwise ...