enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   7 thumb screw 6-32 × 6 mm for 2.5” drive tray, expansion slots; 4 hexagon screw 6-32 × 6 mm for psu; 21 phillips screw 6-32 × 5 mm for motherboard, 3.5” harddisk tray; 12 phillips screw M3 × 5 mm for 2.5” harddrive; 16 KB5 x 10 mm for fans; 9 standoff 6-32 × 6.5 + 4 mm for motherboard; 1 positioning standoff 6-32 × 6.5 + 4 mm for ...

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   [15]: 85–86 They also allow for the use of angled screw drivers and trim head screws. The socket-headed Robertson screws reduce cam-out, stop a power tool when set, and can be removed if painted over or old and rusty. [15]: 85–86 In industry, they speed up production and reduce product damage. [15]: 85–86

4. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).

5. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Isometric projection of a grub screw with a hex socket head. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts. The detent, however ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A bolt that is threaded all the way to the head. An ASME B18.2.1 compliant set/tap bolt has the same tolerances as an ASME B18.2.1 compliant hex cap screw. set screw: grub screw: A set screw is generally a headless screw but can be any screw used to fix a rotating part to a shaft, such as a line shaft or countershaft. The set screw is driven ...

7. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   The International Electrotechnical Commission (IEC) has standardized a set of multi-pin screw plugs matching ISO metric screw thread, available in M5, M8 and M12 sizes. M5 connectors are very low current, typically only used for signal wiring, while some M8 pin arrangements are rated for up to 3 A, and some M12 arrangements are available up to ...