Search results
Results from the WOW.Com Content Network
According to these definitions the transition layer is 0–500 feet (0–150 m) thick. Aircraft are not normally assigned to fly at the "'transition level'" as this would provide inadequate separation from traffic flying on QNH at the transition altitude. Instead, the lowest usable "'flight level'" is the transition level plus 500 ft.
An orbital spaceflight (or orbital flight) is a spaceflight in which a spacecraft is placed on a trajectory where it could remain in space for at least one orbit. To do this around the Earth, it must be on a free trajectory which has an altitude at perigee (altitude at closest approach) around 80 kilometers (50 mi); this is the boundary of ...
The highest altitude obtained by a paper plane was previously held by the Paper Aircraft Released Into Space (PARIS) project, which was released at an altitude of 27.307 kilometres (89,590 ft), from a helium balloon that was launched approximately 80 kilometres (50 mi) west of Madrid, Spain on October 28, 2010, and recorded by The Register's ...
Because lift and drag are both aerodynamic forces, the ratio of lift to drag is an indication of the aerodynamic efficiency of the airplane. The lift to drag ratio is the L/D ratio, pronounced "L over D ratio." An airplane has a high L/D ratio if it produces a large amount of lift or a small amount of drag.
The Cessna 172 Skyhawk is the most produced aircraft in history.. An aircraft (pl.: aircraft) is a vehicle that is able to fly by gaining support from the air.It counters the force of gravity by using either static lift or the dynamic lift of an airfoil, [1] or, in a few cases, direct downward thrust from its engines.
A wide variety of sources [5] [6] [7] define LEO in terms of altitude.The altitude of an object in an elliptic orbit can vary significantly along the orbit. Even for circular orbits, the altitude above ground can vary by as much as 30 km (19 mi) (especially for polar orbits) due to the oblateness of Earth's spheroid figure and local topography.
Airplanes can structurally handle much more than Mother Nature is ever likely to throw at them, but that’s just one aspect of the “go” or “no-go” decision for a flight.
Landing of Hawker Sea Fury FB 10. Landing is the last part of a flight, where a flying animal, aircraft, or spacecraft returns to the ground. When the flying object returns to water, the process is called alighting, although it is commonly called "landing", "touchdown" a or "splashdown" as well.