Search results
Results from the WOW.Com Content Network
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
Black-box testing is the software analog to FTC. At the end of the system development, a functional test verifies that the requirements of the system are met. Component Test Cases (CTC) are a physical analog to White-box testing. CTC verify that components satisfy the allocated FRs and ICs.
A component selected for testing is a Unit Under Test (UUT). Operational Safety, Suitability, and Effectiveness (OSS&E) policy and instructions require consistency in the disciplined engineering process used to ensure that activities such as maintenance repairs and part substitutions do not degrade system or end-item baselined characteristics ...
Variety of loose pogo pins and pogo pins in 3-pin assembly holders and with Pick and Place caps Sectional drawing of a pogo pin, showing the plunger, barrel, and spring. A pogo pin or spring-loaded pin is a type of electrical connector mechanism with spring plungers that is used in many modern electronic applications and in the electronics testing industry. [1]
Unit testing, a.k.a. component or module testing, is a form of software testing by which isolated source code is tested to validate expected behavior. [ 1 ] Unit testing describes tests that are run at the unit-level to contrast testing at the integration or system level.
Assembly: Preliminary assembly of components and confirmation of production approval. Typically another advance payment is made. Delivery: Delivering of components and final assembly/installation, usually at client location. Trial period: After the customer has tested and accepted the product, final payment and contract settlement are made.
Assembly modeling is a technology and method used by computer-aided design and product visualization computer software systems to handle multiple files that represent components within a product. [1] The components within an assembly are represented as solid or surface models.
However, if the test cases and their results are not recorded properly, the entire integration process will be more complicated and may prevent the testing team from achieving the goal of integration testing. In bottom-up testing, the lowest level components are tested first, and are then used to facilitate the testing of higher level components.