Search results
Results from the WOW.Com Content Network
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
In 1973, ECMA-35 and ISO 2022 [18] attempted to define a method so an 8-bit "extended ASCII" code could be converted to a corresponding 7-bit code, and vice versa. [19] In a 7-bit environment, the Shift Out would change the meaning of the 96 bytes 0x20 through 0x7F [a] [21] (i.e. all but the C0 control codes), to be the characters that an 8-bit environment would print if it used the same code ...
UCHAR_MAX, USHRT_MAX, UINT_MAX, ULONG_MAX, ULLONG_MAX(C99) – maximum possible value of unsigned integer types: unsigned char, unsigned short, unsigned int, unsigned long, unsigned long long; CHAR_MIN – minimum possible value of char; CHAR_MAX – maximum possible value of char; MB_LEN_MAX – maximum number of bytes in a multibyte character
Bit banging is a term of art that describes a method of digital data transmission as using general-purpose input/output (GPIO) instead of computer hardware that is intended specifically for data communication.' [1] Controlling software is responsible for satisfying protocol requirements including timing which can be challenging due to limited host system resources and competing demands on the ...
The first serial communication devices (with fixed-length pulses) were rotating mechanical switches (commutators). Various character codes using 5, 6, 7, or 8 data bits became common in teleprinters and later as computer peripherals. The teletypewriter made an excellent general-purpose I/O device for a small computer.
SCPI commands to an instrument may either perform a set operation (e.g. switching a power supply on) or a query operation (e.g. reading a voltage). Queries are issued to an instrument by appending a question-mark to the end of a command. Some commands can be used for both setting and querying an instrument.
To determine if a number is a power of two, conceptually we may repeatedly do integer divide by two until the number won't divide by 2 evenly; if the only factor left is 1, the original number was a power of 2. Using bit and logical operators, there is a simple expression which will return true (1) or false (0):
NOPs are often involved when cracking software that checks for serial numbers, specific hardware or software requirements, presence or absence of hardware dongles, etc. in the form of a NOP slide. This process is accomplished by altering functions and subroutines to bypass security checks and instead simply return the expected value being ...