Search results
Results from the WOW.Com Content Network
Autodesk Revit is a building information modeling software for architects, structural engineers, mechanical, electrical, and plumbing (MEP) engineers, and contractors. The original software was developed by Charles River Software, founded in 1997, renamed Revit Technology Corporation in 2000 and acquired by Autodesk in 2002.
Base isolators for seismic isolation of buildings, bridges, etc. Base isolators made of layers of neoprene and steel with a low horizontal stiffness are used to lower the natural frequency of the building. Some other base isolators are designed to slide, preventing the transfer of energy from the ground to the building. Tuned mass dampers
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
Everlight EL817 phototransistor opto-isolator in DIP-4 package Halo TG110-S050N2RL 10/100BASE-TX Ethernet pulse transformer in SO-16 package, with the underside shown on the right. Galvanic isolation is a principle of isolating functional sections of electrical systems to prevent current flow; no direct conduction path is permitted.
ANSI and IEC standard schematic symbol for a circulator (with each waveguide or transmission line port drawn as a single line, rather than as a pair of conductors). In electrical engineering, a circulator is a passive, non-reciprocal three- or four-port device that only allows a microwave or radio-frequency (RF) signal to exit through the port directly after the one it entered.
Figure 2 shows a Faraday rotator with an input polarizer, and an output analyzer. For a polarization dependent isolator, the angle between the polarizer and the analyzer, , is set to 45°. The Faraday rotator is chosen to give a 45° rotation. Polarization dependent isolators are typically used in free space optical systems.
Barrier isolator is a general term that includes two types of devices: isolators and restricted access barriers (RABS). Both are devices that provide a physical and aerodynamic (air overpressure) barrier between the external clean room environment and a work process.
This is a list of insulation materials used around the world.. Typical R-values are given for various materials and structures as approximations based on the average of available figures and are sorted by lowest value.