Search results
Results from the WOW.Com Content Network
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
The name refers to the ability of the disk to flex along its main axis to account for gear changes and/or small misalignments as rotational speeds change. [2] Flexplates are generally much thinner and lighter than flywheels not only because of the required flexibility, but also due to the smoother coupling action of the torque converter [3] and the elimination of the clutch surface.
Historical Word serial interfaces connect a hard disk drive to a bus adapter [b] with one cable for combined data/control. (As for all early interfaces above, each drive also has an additional power cable, usually direct to the power supply unit.) The earliest versions of these interfaces typically had an 8 bit parallel data transfer to/from ...
The NGSFF connector is electrically and dimensionally compatible with M.2 (revision 1.1)'s connector; new functionality is achieved through previously unused (N/C) pins. [27] The main changes compared to M.2 are: The width (or "height") of the SSD is increased from 22 mm to 30.5 mm; the thickness is increased from 3.88 mm to 4.38 mm.
Chip-on-flex: Variation of COB, where a chip is mounted directly to a flex circuit. Unlike COB, it may not use wires nor be covered with epoxy, using underfill instead. TAB: Tape-automated bonding: Variation of COF, where a flip chip is mounted directly to a flex circuit without the use of bonding wires. Used by LCD driver ICs. COG: Chip-on-glass
A driveshaft coupling. Note the split damage beginning to appear, likely due to the large axial displacement. A giubo. A giubo (/ ˈ dʒ uː b oʊ / JOO-boh; etymology: giunto Boschi, "Boschi joint"), also known as a 'flexdisc', and sometimes misspelled as guibo, is a flexible coupling used to transmit rotational torque between the drive shaft and the companion flange on mechanical devices ...
SSDs with U.2 interface. U.2 (pronounced 'u-dot-2' [1]), using the port SFF-8639, is a computer interface standard for connecting solid-state drives (SSDs) to a computer. It covers the physical connector, electrical characteristics, and communication protocols.
The male PCB connector on the 3½-inch floppy drive is normally a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, [4] the straight model is AMP 171825-4. [ 5 ] The shape of the connector housing makes it very easy to determine the pin number allocations by visual inspection.